主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2025, Vol. 50 ›› Issue (11): 36-41,59.DOI: 10.16638/j.cnki.1671-7988.2025.011.007

• 新能源汽车 • 上一篇    

某 DHT 混动变速器车型极限工况电机过热 问题分析与优化

刘井学，马忠驰，左波涛，黄伟山，刘义强   

  1. 宁波吉利罗佑发动机零部件有限公司
  • 发布日期:2025-06-06
  • 通讯作者: 刘井学
  • 作者简介:刘井学（1993－），男，工程师，研究方向为混动变速器控制及标定

Analysis and Optimization of Motor Overheating Problem under Extreme Working Conditions of a DHT Hybrid Transmission Model

LIU Jingxue, MA Zhongchi, ZUO Botao, HUANG Weishan, LIU Yiqiang   

  1. Ningbo Geely Royal Engine Components Company Limited
  • Published:2025-06-06
  • Contact: LIU Jingxue

PDF

摘要： 文章为解决车辆在山路、拖车等极限工况下混动变速器中驱动电机过热的问题，从冷 却系统的冷却能力、驱动电机的发热功率、整车控制策略等方面进行了分析，对电机过热问 题提出了以下优化措施：提高油泵转速限值、调整流量阀开度来加大电机侧冷却流量、优化 电机限扭策略。通过整车全工况转毂台架验证和实车验证发现，以上措施能够有效地解决此 车在山路、拖车工况下电机过热的问题，可对搭载此混动变速器的车型进行措施横展，也对 混动车型在应对高负载类工况电机过热问题处理上提供了借鉴。

关键词: 驱动电机；3DHT；混动变速器；电机过热

Abstract: This article aims to solve the problem of overheating of the drive motor in hybrid transmissions under extreme working conditions such as mountain roads and trailers. It analyzes the cooling capacity of the cooling system, the heating power of the drive motor, and the overall control strategy of the vehicle. The following optimization measures are proposed for the problem of motor overheating: increasing the speed limit of the oil pump, adjusting the opening of the flow valve to increase the cooling flow on the motor side, and optimizing the motor torque limit strategy. Through full condition hub test and actual vehicle verification, it is found that the above measures can effectively solve the problem of motor overheating in mountain roads and trailer working conditions of this vehicle. Measures can be taken horizontally for models equipped with this hybrid transmission, and also provide reference for hybrid models in dealing with motor overheating problems under high load working conditions.

Key words: drive motor; 3DHT; hybrid transmission; motor overheating