主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2023, Vol. 48 ›› Issue (8): 174-177.DOI: 10.16638/j.cnki.1671-7988.2023.08.032

• 工艺装备 • 上一篇    下一篇

某双胎轻卡驱动桥的轻量化设计和有限元分析

陈冠旭，聂采顺，李永放，孙伟元   

  1. 四川建安工业有限责任公司 研发中心
  • 出版日期:2023-04-30 发布日期:2023-04-30
  • 通讯作者: 陈冠旭
  • 作者简介:陈冠旭（1996—），男，硕士，研究方向为汽车后桥研发设计，E-mail:gxchen96@gmail.com。

Lightweight Design and Finite Element Analysis of Rear Drive Axle Housing of a Twin-tire Light Truck

CHEN Guanxu, NIE Caishun, LI Yongfang, SUN Weiyuan   

  1. Research and Development Center, Sichuan Jian'an Industrial Company Limited
  • Online:2023-04-30 Published:2023-04-30
  • Contact: CHEN Guanxu

PDF

摘要： 汽车轻量化设计是在确保整车性能的基础上，对汽车整备质量进行最小化的设计。驱 动桥的强度及刚度对整车的安全可靠有直接影响，卡车在承载质量以及使用寿命上更高的要 求。论文在保证轻卡的强度和安全性能前提下，基于 ABAQUS 软件对整体后桥的疲劳耐久性 做出分析论证。最终定型的 85 mm×85 mm×6 mm 方管整体冲焊式桥壳、上下半体材料均采用 高强度钢 QSTE460TM。在各工况条件下，都满足强度及刚度要求，分析结果表明，桥壳的轻 量化设计是可行的。

关键词: 轻量化设计；驱动桥；ABAQUS；高强度材料

Abstract: Automobile lightweight design is based on ensuring the performance of the whole vehicle, the design of the vehicle maintenance quality for energy saving. The strength and rigidity of the drive axle have a direct impact on the safety and reliability of the vehicle. There are more clear requirements on the bearing quality and service life of the truck. this paper analyzes and demonstrates the fatigue durability of the whole axle housing based on ABAQUS analysis on the premise of ensuring the strength and safety performance of the light truck. The final 85 mm×85 mm× 6 mm square tube steel plate integral blanking welding axle, which is made of high strength steel QSTE460TM for the upper and lower parts. Under various working conditions, it is satisfied with the strength and rigidity of the axle. The analysis results indicate that the lightweight design of the drive axle is feasible.

Key words: Lightweight design; Drive axle; ABAQUS; High-strength materials