主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2024, Vol. 49 ›› Issue (2): 110-114.DOI: 10.16638/j.cnki.1671-7988.2024.002.020

• 测试试验 • 上一篇    

基于侧面柱碰撞工况驾驶员肩部损伤优化

郑光洁，王 德，韩菲菲，王晓鑫   

  1. 中汽研（天津）汽车工程研究院有限公司
  • 发布日期:2024-01-30
  • 通讯作者: 郑光洁
  • 作者简介:郑光洁（1986－），女，硕士，工程师，研究方向为汽车被动安全性能开发，E-mail:zhengguangjie@catarc.ac.cn。

Optimization of the Driver Shoulder Injury Based on the Side Pole Collision Condition

ZHENG Guangjie, WANG De, HAN Feifei, WANG Xiaoxin   

  1. CATARC (Tianjin) Automotive Engineering Research Institute Company Limited
  • Published:2024-01-30
  • Contact: ZHENG Guangjie

PDF

摘要： 对比三款车型假人肩部力曲线，发现在侧面柱碰撞工况中，肩部力超出 capping 值的情 况较为常见。文章通过零部件布置、内饰关重件设计及气囊包型三个方面分析了其对于假人 肩部力的影响。提出合理布置车门及 B 柱饰板内强度较硬的塑料件、选择合适的内饰材料、 合理设计气囊包型对于假人肩部力有显著的改善效果。

关键词: 侧面柱碰撞工况；WorldSID 50th 假人；肩部力；材料刚度；气囊包型

Abstract: By comparing the shoulder force curves of three vehicles, it is found that the capping value of shoulder force is more common in side pole collision condition. This paper analyzes its influence on the shoulder force of the dummy from three aspects: parts layout, interior design and airbag package type. Reasonable arrangement of hard plastic parts in the door and B-pillar trim plate, selection of appropriate interior materials and reasonable design of airbag envelope can significantly improve the shoulder force of the dummy.

Key words: Side pole collision condition; WorldSID 50th dummy; Shoulder force; Material stiffness; Airbag envelope