主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2022, Vol. 47 ›› Issue (16): 79-83.DOI: 10.16638/j.cnki.1671-7988.2022.016.016

• 测试试验 • 上一篇    

油冷多合一电驱总成油堵密封分析

胡 迪 1，何胜平 1，于爱军 1，林志明 2，公 平 2，于 帅 2   

  1. 1.株洲齿轮有限责任公司，2.青岛海力威新材料科技股份有限公司
  • 发布日期:2022-09-30
  • 通讯作者: 胡 迪
  • 作者简介:胡迪（1984—），男，硕士，工程师，研究方向为新能源减速器开发，E-mail:hudi@weichaizc.com。
  • 基金资助:
    湖南省高新技术产业科技创新引领计划（2021GK4033）；中央引导地方科技发展专项（2021QZY009）。

Sealing Analysis of Oil Cooled Multi-in-one Electric Drive Assembly

HU Di1 , HE Shengping1, YU Aijun1, LIN Zhiming2 , GONG Ping2, YU Shuai2   

  1. 1.Zhuzhou Gear Company Liability Limited,2.Qingdao Hailiwei New Material Technology Company Limited
  • Published:2022-09-30
  • Contact: HU Di

PDF

摘要： 某款新能源减速箱在开发路试过程中，发现存在冷却润滑油道堵头漏油问题。通过计 算机辅助工程（CAE）仿真分析软件对铜垫片密封性能分析，发现壳体粗糙度对润滑性能影 响很大，存在漏油的风险。采用有限元仿真分析了 E 型橡胶垫油堵的密封性能，并经过气密 试验测得泄露大幅降低，可承受压力最大达到 200 kPa。结果表明，E 型橡胶垫油堵不仅能消 除油堵漏油情况，而且 E 型橡胶垫反装对密封性能有较大影响。

关键词: 油冷多合一；电驱总成油堵；密封分析；铜垫片；E 型橡胶垫

Abstract: During the road test of a gearbox of electric vehicle, the problem of leakage from the plug of lubricating oil route was found. Through the analysis of sealing performance of copper gasket by computer adied engineering (CAE) simulation, it is found that the roughness of housing has a great influence on sealing performance and there is a risk of leakage. The sealing performance of type E rubber washer was analyzed by finite element simulation, and the leakage was greatly reduced by airtight test, and the maximum pressure was up to 200 kPa. The results show that type E rubber washer can not only eliminate the leakage problem, and also the sealing performance of type E rubber washer in reverse loading has a great impact.

Key words: Oil cooled multi-in-one; Electric drive assembly; Sealing analysis; Copper gaskets; type-E rubber washer