主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2022, Vol. 47 ›› Issue (16): 73-78.DOI: 10.16638/j.cnki.1671-7988.2022.016.015

• 设计研究 • 上一篇    

基于线结构光的车身 R 角检测方法

曾 贺   

  1. 上汽大通汽车有限公司 制造工程部
  • 发布日期:2022-09-30
  • 通讯作者: 曾 贺
  • 作者简介:曾贺（1978—），男，硕士，高级工程师，研究方向为整车设计开发与验证，E-mail:zenghe@Hotmail.com。

R-angle Detection Method for Bodywork Based on Line Structured Light

ZENG He   

  1. Department of Vehicle Engineering, SAIC MAXUS Auto Company Limited
  • Published:2022-09-30
  • Contact: ZENG He

PDF

摘要： 针对车身 R 角测量过程会受到测量角度和测量环境的影响，导致提取特征信息少、拟 合精度不高的问题，提出一种圆弧特征数据提取与拟合的方法。先对实测数据利用双边滤波 消除噪声数据，然后利用所提出方法可以有效针对不完整圆弧的点云进行特征数据筛选，并 通过迭代重加权最小二乘算法进行特征数据的拟合。文章所提出方法经过实验验证，测量结 果与三坐标测量结果进行对比，线激光测量平均误差为 0.018 mm，相比于 R 规测量平均误差 降低了 0.006 1 mm。

关键词: 线结构光；车身 R 角；检测方法

Abstract: The R Angle measurement process of auto-body will be affected by the measurement Angle and measurement environment, resulting in less extracted feature information and low fitting accuracy. In this paper, a feature data extraction and fitting method of circular arc is proposed. Firstly, the noise data is eliminated by bilateral filtering, and then the feature data can be effectively screened against the point cloud of incomplete circular arc by using the proposed method, and the feature data can be fitted by iterative reweighted least square algorithm. Based on the experimental verification of the proposed method, the measurement results were compared with the coordinate measuring machine (CMM) results, and the average error of the line laser measurement was 0.018 mm, which was 0.006 1 mm lower than the average error of the R gauge measurement.

Key words: Line structured light; Body R-angle; Detection method