主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2022, Vol. 48 ›› Issue (2): 95-100.DOI: 10.16638/j.cnki.1671-7988.2023.02.018

• 设计研究 • 上一篇    

基于车辆悬架的载荷设计方法

程 凯，孟凡亮，张关良，刘 杨   

  1. 奇瑞汽车股份有限公司 汽车工程技术研发总院
  • 出版日期:2023-01-30 发布日期:2023-01-30
  • 通讯作者: 程 凯
  • 作者简介:程凯（1985—），男，硕士，研究方向为结构耐久，E-mail:chengkai@mychery.com。

Load Design Method Based on Vehicle Suspension

CHENG Kai, MENG Fanliang, ZHANG Guanliang, Liu Yang   

  1. Chery Automobile Company Limited
  • Online:2023-01-30 Published:2023-01-30
  • Contact: CHENG Kai

PDF

摘要： 汽车的轻量化设计一直是各大主机厂追求的设计方向，尤其是近几年电动车的发展， 市场对续航能力的要求越来越高，而整车重量与续航强相关，因此，轻量化的设计显得尤为 重要，而轻量化设计的源头就是悬架的载荷设计。论文基于某多连杆后悬架结构，提出一种 载荷设计的方法，综合考虑悬架的载荷分配及运动学特性和动力学特性（KC），通过试验设 计（DOE）及最优化设计手段寻求硬点最佳分布，达到降低悬架载荷目的，从而为结构轻量 化设计提供良好基础。

关键词: DOE；CAE 仿真；载荷设计；硬点优化；悬架设计；车辆悬架；轻量化设计

Abstract: Lightweight design of automobile has always been the ultimate goal pursued by major Original equipment manufacturers (OEMs). Especially in recent years, with the development of new energy vehicles, the market has higher and higher requirements for endurance capacity, and the weight of the whole vehicle is related to the endurance, so lightweight design is particularly important. The source of lightweight design is the load design of suspension. Based on a multi-link rear suspension structure, this paper proposes a load design method. Its main idea is to comprehensively consider the load distribution and kinematic compliance (KC) performance of the suspension, and seek the best distribution of hard points through design of experiment (DOE) and optimization method, achieve the purpose of reducing suspension load, so as to lay a good foundation for the lightweight design of the structure.

Key words: DOE; CAE simulation; Load design; Hard point optimization; Suspension design; Vehicle suspension; Lightweight design