主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2023, Vol. 48 ›› Issue (13): 69-72.DOI: 10.16638/j.cnki.1671-7988.2023.013.013

• 设计研究 • 上一篇    

基于有限元法的某柴油机旋压皮带轮故障分析

亓 斌，刘伦伦，孙武海   

  1. 潍柴动力股份有限公司 内燃机可靠性国家重点实验室
  • 出版日期:2023-07-15 发布日期:2023-07-15
  • 通讯作者: 亓 斌
  • 作者简介:亓斌（1989－），男，工程师，研究方向为机械设计、无级变速箱、柴油机、自动控制等，E-mail:1020079330 @qq.com。

Fracture Fault Analysis of Spinning Pulley in a Diesel Engine Based on Finite Element Method

QI Bin, LIU Lunlun, SUN Wuhai   

  1. State Key Laboratory of Engine Reliability, Weichai Power Company Limited
  • Online:2023-07-15 Published:2023-07-15
  • Contact: QI Bin

PDF

摘要： 针对某发动机耐久试验过程中出现的旋压皮带轮断裂故障，基于试验状态载荷边界， 利用 ABAQUS 软件对旋压皮带轮系统进行了应力仿真，结果显示皮带轮应力安全系数不满足 设计要求。根据应力结果对旋压皮带轮系统进行了改进，优化后皮带轮最大应力下降 35%， 满足产品设计要求并通过了耐久考核试验。该结构可靠性分析方法对旋压皮带轮设计具有重 要指导作用。

关键词: 旋压皮带轮；ABAQUS 软件；耐久考核；结构优化

Abstract: The spinning pulley of an engine broke in the durability test. To address this issue, the stress of the spinning pulley system is analyzed using the ABAQUS software based on test loading conditions, the analyses show that the stress safety factor of the spinning pulley cannot meet the design requirement. The maximum stress decline 35% by optimizing the spinning pulley system based on previous analysis, reaching the design requirement. The improved spinning pulley passed the durability test. This indicates that this structural reliability analysis method can effectively guide the design of the spinning pulley.

Key words: Spinning pulley; ABAQUS software; Durability test; Structure optimization