主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2022, Vol. 47 ›› Issue (10): 143-148.DOI: 10.16638/j.cnki.1671-7988.2022.010.030

• 标准·法规·管理 • 上一篇    

虚拟评审技术应用于工程样车开发中的 可行性分析

闫仕军，王涟清，张关华   

  1. 泛亚汽车技术中心有限公司 产品数据及知识工程部
  • 出版日期:2022-05-30 发布日期:2022-05-30
  • 通讯作者: 闫仕军
  • 作者简介:闫仕军（1968—），男，硕士，高级工程师，研究方向为汽车自动化设计、产品数据智能化管理和法规认证 策略，E-mail：Shijun_Yan@PATAC.com.cn。

Feasibility Analysis of the Application of Virtual Review Technology in the Development of Engineering Prototypes

YAN Shijun, WANG Lianqing, ZHANG Guanhua   

  1. Product Data & Knowledge Engineering Department, Pan Asia Technical Automotive Center Company Limited
  • Online:2022-05-30 Published:2022-05-30
  • Contact: YAN Shijun

PDF

摘要： 随着新车迭代加快、产品配置越来越复杂，传统汽车制造企业依靠实体试制提升产品 质量的方式已经不能满足市场需求。文章提出将虚拟评审技术应用于工程样车开发，并利用 虚拟评审技术优势对整车及子系统各项性能进行全方位验证，在实体造车前将问题风险降至 最低。文章分别从工程样车虚拟评审技术介绍、工程样车虚拟评审环境支持及工程样车虚拟 评审机制各方面展开讨论。最后论述了该研究方法对于企业提升产品竞争力的重要意义。

关键词: 工程样车试制；虚拟评审；可行性分析

Abstract: With the acceleration of new car iterations and the increasingly complex product configurations, traditional auto manufacturing companies relying on physical trial production to improve product quality can no longer meet market demand. This paper proposes to apply virtual review technology to the development of engineering prototypes, and to use the advantages of virtual review technology to comprehensively verify the performance of the whole vehicle and subsystems, so as to minimize the risk of problems before the physical vehicle is built. The article discusses from the introduction of virtual review technology for engineering prototypes, the environment support for virtual review of engineering prototypes, and the virtual review mechanism for engineering prototypes. Finally, the significance of this research method for enterprises to enhance product competitiveness is discussed.

Key words: Engineering prototype vehicles; Virtual review; Feasibility analysis