主办：陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊：1976年
汽车实用技术

汽车实用技术 ›› 2021, Vol. 46 ›› Issue (15): 98-100.DOI: 10.16638/j.cnki.1671-7988.2021.015.027

• 设计研究 • 上一篇    下一篇

某车型后减振器异响分析与优化

丁都都, 罗谢盼, 李奕宝, 崔红亮   

  1. 广州汽车集团股份有限公司汽车工程研究院,广东 广州 511434
  • 出版日期:2021-08-15 发布日期:2021-08-20
  • 作者简介:丁都都,就职于广州汽车集团股份有限公司汽车工程研究院。

Analysis and Optimization of Abnormal Noise of Rear Shock Absorber of a Vehicle

DING Dudu, LUO Xiepan, LI Yibao, CUI Hongliang   

  1. Guangzhou Automotive Group Co., Ltd., Automotive Engineering Research Institute, Guangdong Guangzhou 511434
  • Online:2021-08-15 Published:2021-08-20

PDF

摘要： 针对某车型在扭曲路工况下后悬异响问题,通过客观数据测试,后减振器上吊环、安装螺栓、车身位置振动频率最大。经过拆解分析,该异响是由于减振器活塞阀面尺寸超差和车身螺纹套管平面焊渣引起,最后优化活塞模具及车身螺栓管焊接工艺解决了该问题。

关键词: 异响, 减振器, 活塞

Abstract: In view of the problem of rear suspension abnormal noise of a vehicle under the condition of twisted road, through the test of objective data, the vibration amplitude of the upper eye, mounting bolt and body position on the rear shock absorber is the highest. After disassembled and analysised, the abnormal noise is caused by out of tolerance of piston face size of shock absorber and plane welding slag of body screw sleeve. Finally, the welding process of piston mould and body bolt pipe is optimized to solve the problem.

Key words: Abnormal noise, Shock absorber, Piston

中图分类号: