主办:陕西省汽车工程学会
ISSN 1671-7988  CN 61-1394/TH
创刊:1976年

汽车实用技术 ›› 2023, Vol. 48 ›› Issue (11): 1-5.DOI: 10.16638/j.cnki.1671-7988.2023.011.001

• 新能源汽车 •    

基于 FEA 的电动汽车电池模组散热 结构设计与分析

徐子祥,戴嘉杰,翟豪瑞*,刘文迪,万海建,王 安,熊 新   

  1. 盐城工学院 汽车工程学院
  • 出版日期:2023-06-15 发布日期:2023-06-15
  • 通讯作者: 翟豪瑞
  • 作者简介:徐子祥(2001-),男,研究方向为新能源汽车电池 CFD 仿真分析,E-mail:1756343795@qq.com。
  • 基金资助:
    江苏省大学生创新创业项目(202110305042Y)。

Design and Analysis of Heat Dissipation Structure of a Battery Module for Electric Vehicles Based on FEA

XU Zixiang, DAI Jiajie, ZHAI Haorui* , LIU Wendi, WAN Haijian, WANG An, XIONG Xin   

  1. School of Automotive Engineering, Yancheng Institute of Technology
  • Online:2023-06-15 Published:2023-06-15
  • Contact: ZHAI Haorui

摘要: 论文设计了一套适用于电动汽车的模组结构并分析验证了其水冷散热效能。首先建立 单节电芯的热模型,然后建立绝热模组产热模型,了解模组的温升及温差情况后,在自然放 电的情况下,施加水冷散热,分析水流不同的换热量对电池模组温度变化的影响。最终分析 得出,设计的模组结构使用水冷散热效果明显,能够较快地降低电池模块温度。

关键词: 电池模组;水冷散热;电动汽车;有限元分析

Abstract: This paper designs a set of module structure suitable for electric vehicles and analyzes its water-cooling and heat dissipation efficiency. Firstly, establishes the heat model of single cell, and then the heat generation model of adiabatic module is built. After considering the situation of temperature rise and difference of the module, water-cooling is applied to dissipate heat under the condition of natural discharge, and the change of temperature of the battery module under different heat transfer of water flow is analyzed. The final analysis shows that the heat dissipation effect of using water-cooling for this module structure is obvious, which can quickly reduce the temperature of the battery module.

Key words: Battery module; Water-cooling heat dissipation; Electric vehicles; Finite element analysis